top of page

Painting 3D squares

This blog post will cover some of the techniques you can use to paint wood minis and interchangeable square inserts... and just about anything else that has laser cut shapes.


A separate blog post for painting the display frames is here.




BEFORE YOU BEGIN:


Throughout the seasons you can find DIY Art kits here or ask to have a workshop converted to a kit. If you have your own supplies from a craft store, feel free to follow along below!


Your wood shapes will either come loose, attached to adjacent pieces with masking tape or inserted into a mask. This is to make it easier to figure out which parts puzzle together. The complexity and range of the designs vary greatly.


I will use a set of all-season laundry-themed squares to demonstrate, but all techniques can be applied to any 3D wood craft offered by Three & Me and beyond.


Before painting, insert your squares into your ladder or frame to see which direction fits best. Due to minor variations in wood thickness and composition, as well as raw material variations, squares may fit better one way or another. Establish best fit BEFORE painting! Please note too, that using too much paint or adding water to your projects may swell the inserts, causing tighter fits. If this happens, use sandpaper to sand down the edges of your square.



If you look at the back of complex designs, you will see masking tape or a clear film that is keeping your design together. Leave them connected until you are ready to paint them, or you may loose tiny pieces or forget which pieces fit together!



Each set of shapes will have a base square. You will need to paint the base square in whatever background color you choose or attach wallpaper/ scrapbook paper/ giftwrap etc onto it for a unique twist. This will be covered in Part 1 below.

While the background dries, you get to paint the cutout design that will be glued on top of it. The most fun stage of all and is covered in Part 2 below.




PART 1:


PAINTING THE BASES:


The bases can be painted in any colors you desire. But where to begin?!


Here are a few thoughts on selecting colors:


1. Keep the base simple in color and texture if the design you're attaching on top of it is complex or busy.

2. A clean base goes well with an ornate design and vice versa.

3. Classic base colors such as white, black or wood stain go with almost everything.

4. Seasonal colors work well for bases, such as orange during the fall, green at St Paddy's, red at Christmas etc. Don't be shy to add a splash of color to one of your squares to see it pop.

5. Ombre techniques (dark to light in a couple of shades of the same color) can be very effective behind the right design.

6. If your design is simple, such as a heart cutout, leaf or other simple shape, you can go bananas with the base and even paint patterns, dots or stripes on it.

7. There really are no rules! Do what your heart desires and if you decide it's not right, you can always paint over it!

8. Have fun!


Get your supplies ready and let's start!



WOOD GRAIN BASE:


You will need:

  • acrylic or chalk paint

  • sponge brush for smooth finish or regular paintbrush for texture

  • avoid adding water, as it maty swell the wood base


Works well for:

any design where you want to see the wood through the paint.


Colors:

brown, grey, whitewash or any other color in a sparse application


  • Dry brush a sparing amount of paint onto your base.

  • Wipe off excess color with a paper towel or rag.

  • for deeper coverage add additional coats in the same or different tones.

  • See the clip below for technique.





SOLID COLORS:



You will need:

  • acrylic paint, chalk paint or spray paint

  • sponge brush for smooth finish or regular paintbrush for texture


Works well for:

solid backgrounds, with full coverage of the base, with no shading and may require numerous coats


Colors:

white, black or any other color in a solid application


  • Drybrush a sparing amount of paint onto your base.

  • Wipe off excess color on the edges with a paper towel or rag.

  • Allow the base to dry fully before applying additional coats of paint.

  • For spray paint, apply 2-3 light coats of spray paint in a well-ventilated area, drying between layers.

  • See the clip below for the paint technique. Repeat as necessary.




Examples of solid backgrounds:




OMBRE OR SHADED TECHNIQUES:


You will need:

  • acrylic or chalk paint in a variety of shades

  • your main color with white, and or another color for more diversity, eg. orange, yellow, white.

  • makeup wedges


Works well for:

backgrounds in multiple colors or shades of the same color, to create an interesting texture behind a simple design.


Colors:

Pick colors that go well together or blend into each other naturally.

Trying to shade colors that do not blend into each other naturally, will not work as well, eg. red and green will blend into brown, but red and yellow blend well into each other. You can use white, or sometimes a hint of black, to help transition the colors into each other.


  • Using a makeup wedge, blot a sparing amount of paint onto your base.

  • Recharge your wedge with the same color and a bit of white or second color.

  • Keep working your way down the base, adding more white/ second color.

  • Once the base is completely covered, work the colors together by blotting the same wedge over the colors until they merge seamlessly.

  • Wipe off excess color on the edges with a paper towel or rag.

  • Allow the base to dry fully before applying additional coats of paint.


See the clip below for paint technique.



You can work the colors from top to bottom horizontally or from center to edge in a circular motion.


Examples of blended/ shaded or ombre backgrounds:




PART 2:


PAINTING THE WOOD SHAPE DESIGNS:



You will need:


  • paint: acrylic, chalk or spray paint work great

  • brushes, sponges, make-up wedges

  • masking tape

  • optional accessories, such as nails, matches, toothpicks, weeding tools, dental picks for fine-tuning

  • sandpaper for distressing (optional)

  • paper towels for dabbing messes and sticky fingers

  • paper plate for blending paints



If your design is attached with tape, remove it, and separate out all your elements.




Paint all your like colors simultaneously. You'll need very little paint!

Use a makeup wedge for easy, smooth application.

Dab the wedge into the paint and then wipe off excess, so that it doesn't run down your design.

Small paint brushes work too, just be careful that you're not applying too much paint.




See a technique below:




Don't be shy to blend shades of colors.

Dip part of your wedge into white or black, blot off excess and run over an edge for shading.

Or add a splash of color to white for variety.



Get creative with matches, nails, toothpicks etc.

Dip a match into paint to stamp dots or make stripes.

Use a straw to get circles!




For painting very small pieces, you can leave them in the mask or attach them to the sticky side of masking tape for easier color application. Otherwise your fingers will look super-colorful when you're done! They will anyway, but watch the clip below for techniques described above.


Allow all your elements to dry fully.

Adjust colors and textures where necessary.



PART 3:


PUTTING IT ALL TOGETHER



You will need:


  • all your dry bases

  • your painted elements

  • Glue (unless your pieces are self-adhesive)


My favorite glue is Aleene's Turbo Tacky Glue, because it dries fast and clear. Superglue works too, but I find it dries too fast, in case I need to adjust something. Craft glue can be used, it just takes a little longer to dry. Avoid Hot glue- it's too thick and you'll likely burn all 10 of your fingers before you're done!




Apply glue very sparingly, so that it doesn't squash out from under your design and ruin your beautifully painted pieces!

Alternatively, you can dab a Q-tip or small brush into the glue and dab it on.

See clip below for technique. I used my finger to distribute the glue, but you can always blot it with a paper towel or brush.




For very small elements, like in the washing machine, puzzle the bits together and apply a piece of masking tape over the top. This will make gluing small elements easier.




Flip the attached piece over and apply glue to the back of it.




Position the group onto your base and allow it to dry fully before removing the tape.

Attach all your other elements.

Once firmly adhered, remove the masking tape and your puzzled piece will stay in place!


Repeat with all your inserts.



Place your inserts into your frame or ladder and display proudly!

Inserts should stay in place if the frame/ ladder is angled. If you are hanging it on a wall, use masking tape, double sided tape or velcro to keep the inserts in place.





All the techniques described above can be applied to all the inserts, minis and other 3D designs. To view the blog post n creating the display frames, see here. I can't wait to see what you do with your displays! Please share them with me directly at claire@threeand.me or on social media with tag @threeandme.


See more examples below. Or see what others did with their sets at the end of this post or on Instagram here.


Thanks for joining me!


Warmly,

Claire

xoxo



This is what others did....







#threeandme #fall #ladders #shiplap #halloween #leaningladder #framed #laundry #squares #3d








www.threeand.me art and craft events logo

Reviews

Created. Enjoyed. Reviewed ...

Had the most fun tonight with an amazing instructor and many wonderful friends! Three & Me out did themselves with beautiful presentation and amazing craft that I am excited to display in my home! I look forward to another opportunity to craft with Three & Me in the future!

Camas, WA

What an amazing experience! Claire is an incredible instructor and makes these projects so fun and truly easy for those like me who are not artsy! She is extremely organized and everything is so well thought out and ready in advance. I can hardly wait to take more classes in the future. I would highly recommend Three & Me!

Angela H.

Camas, WA

I just went to my first Three & Me workshop. It was a wonderful experience. Claire is a warm hostess and an excellent instructor. Making everyone feel engaged and successful. The materials are top notch and every detail is well thought out. It’s a great escape for a personal creative moment or a fun way to connect with friends and family while expressing your inner artist.

Camas, WA

Such a fun string art class tonight! Claire is a wonderful instructor and everything was so beautiful; the display, the art, the examples, the supplies, the snacks! So fun!

Camas, WA

This is truly a fun night out! Claire's instruction is helpful, humorous and fun! I love how she allowed us options to be creative and put our own twist on our projects. There is a lot of attention to detail with the set-up, supplies and refreshments which did not go unnoticed.  I can't wait for the next project!

What a fun evening! Claire has thought of every detail and guides you step by step through the whole process! She is such an encourager and makes you feel like you have just made a masterpiece! I highly recommend her classes! I can't wait to take another one!

Camas, WA

I had such a fun evening! Three & Me had everything presented beautifully and organized in a way that made it easy to follow along for those of us that aren't necessarily crafters by nature! Thank you for a fun night!

Courtney H.

Camas, WA

Thank you Claire Houlding for an incredible night! It was so much fun creating with Three & Me!

Hollen F.

Camas, WA

You all did such a great job! Claire Houlding what a fun thing you are starting in our community! Love it. So fun to be there tonight!

Jennifer B.

Camas, WA

I craft a lot at home, but doing crafts in a class with friends is so much better. THREE & ME makes it so easy to do the things I am interested in, without having to find the supplies and figure out how to do it on my own. I've just booked my next ladies night with Claire! I can't wait. 

Vancouver, WA

Tonight, a bunch of lucky ladies got to craft along side one of the very best. Claire's heart, is hands done one of the very best and those of us who were there got to create something amazing that we will proudly display in our homes. Many laughs and much fun was had by all. I highly recommend one of Three & Me classes to anyone in the area! Spread kindness around like confetti!!

Lana E.

Camas, WA

Art is not my strength. I don't have a creative bone in my body. So I came to a workshop because my friend made me... and I made something I now love. I was expecting to sit and watch, but landed up getting fully involved! My husband and kids don't believe that I made it myself. I'm coming again and I'm bringing my sister... she's even worse at crafts than me.

Alyson S.

Washougal, WA

We had such a fun girls night out making Christmas signs. Claire did a wonderful job explaining what to do and they turned out great! We are all looking forward to more events!! Thank you!

Kristine A.

Camas, WA

Please reload

bottom of page